ING Renault F1 Team unveils the R29 in Portugal
The ING Renault F1 Team officially launched its 2009 season yesterday as the new Renault F1 R29 was unveiled to the world’s media at the Algarve Motor Park near Portimao in the south of Portugal. Both the team’s race drivers, Fernando Alonso and Nelson Piquet, were on hand this morning to take the covers off their new challenger as they joined Managing Director Flavio Briatore for a photo call with the R29 in front of the team’s pit garage.
Renault F1 R29 Technical Description
Following the ING Renault F1 Team’s improving performance in 2008, the new R29 is a development in design philosophy aimed at extracting maximum performance from the new aero regulations, slick Bridgestone tyres, and KERS system, whilst further developing the strong features of the R28.
With such radical rules coming into force, particularly with respect to aerodynamics, the team placed great emphasis on maximising the R29’s time in the wind tunnel, with aero development already underway by February 2008. CFD has also played a considerable role in the design of the car and has been particularly valuable in understanding the interaction of the aerodynamic package as a whole.
There has been a concerted effort to save as much weight as possible on the R29 to allow for the introduction of the KERS system. As a result, the design team has moved towards using alternative materials and construction methods, such as the carbon-titanium gearbox casing, increased use of MMC aluminium and magnesium.
Renault started the design work of the KERS system in 2007 in conjunction with Magnetti-Marelli. The system consists of a motor-generator, which is connected to the front of the engine (this charges the battery on braking and releases the energy under acceleration), a battery pack located in the chassis and a KERS control unit.
The front end of the car is dominated by the 2009 aero specification wide front wing which has a driver controlled adjustable incidence flap. This looks very different to previous years being much closer to the ground and has much greater influence on the air flow over the tyres due to its increased span. Great attention has therefore been paid to the end plates which have become much more critical devices than they have been in previous years. The front end also has a more radical front suspension layout with new geometry including inclined wishbones and higher monocoque in order to maximise the new slick tyres and improve aerodynamic efficiency.
The rear of the monocoque under the bodywork has changed considerably with the integration of the KERS system, which has taken a lot of effort to package neatly for the minimum weight. The introduction of this new technology has also influenced the car’s aero package with careful consideration paid to ensure sufficient cooling.
The bodywork appendages, such as winglets, flicks and chimneys have now largely disappeared with the 2009 aero regulations. The surfaces are therefore much simpler and more streamlined, although the R29 still incorporates the R28-type dorsal fin and flush exhaust exits seen on previous Renault F1 cars.
The 2009 rear wing is narrower and higher and reverts back to the centrally-supported single pylon design first introduced on the R26.
The four-race gearbox has a brand new carbon-titanium main case to save weight, and an improved gearshift system developed on the R28, which has also reduced weight and improves performance.
The R29 therefore shares little in common with its predecessor with much of the car designed from a clean sheet of paper. This is particularly true of the aerodynamic package where efforts in the past have concentrated on evolutionary design. The technical team has risen to the challenges of this shake-up in the rules and looks forward to seeing the results of their efforts on the racetrack when the R29 makes its debut this January.
Renault F1 R29 Technical Specifications
Chassis
Moulded carbon fibre and aluminium honeycomb composite monocoque, manufactured by the Renault
F1 Team and designed for maximum strength with minimum weight. RS27 V8 engine installed as a
fully-stressed member.
Front suspension
Carbon fibre top and bottom wishbones operate an inboard rocker via a pushrod system. This is connected to a torsion bar and damper units which are mounted inside the front of the monocoque. MMC aluminium uprights and machined magnesium wheels.
Rear suspension
Carbon fibre top and bottom wishbones operating angled torsion bars and transverse-mounted damper
units mounted on the top of the gearbox casing. MMC aluminium uprights and machined magnesium wheels.
Transmission
Seven-speed semi-automatic carbon-titanium gearbox with reverse gear. "Quickshift system in operation to maximise speed of gearshifts.
Fuel system
Kevlar-reinforced rubber fuel cell by ATL.
KERS
Motor generator unit driving into front of engine with batteries as an energy store.
Cooling system Separate oil and water radiators located in the car's sidepods and cooled using airflow from the car's forward motion
Electrical
MES-Microsoft Standard Electronic Control Unit.
Magnetti-Marelli KERS control unit.
Braking system
Carbon discs and pads (Hitco); calipers and mastercylinders by AP Racing.
Cockpit
Removable driver’s seat made of anatomically formed carbon composite, with six-point harness seat belt. Steering wheel integrates gear change and clutch paddles, front flap adjuster and KERS energy release controls.
Car dimensions and weight
Front track 1450 mm
Rear track 1400 mm
Overall length 4800 mm
Overall height 950 mm
Overall width 1800 mm
Overall weight 605 kg, with driver, cameras and ballast
Renault F1 RS27 Technical Specifications
Capacity 2400 cc
Architecture 90° V8
Weight 95 kg
Max rpm 18,000 rpm
ECU MES SECU
KERS control Magnetti-Marelli
Fuel Total
Oil Total
Battery Renault F1 Team
Identical specification RS27 engines will be supplied to the ING Renault F1 Team and to Red Bull Racing for the 2009 season.
Key People
ING Renault F1 Team Key People
Technical Director Bob Bell
Executive Director of Engineering Pat Symonds
Deputy Managing Director (Engine) Rob White
Deputy MD (Support Operations) André Lainé
Deputy Technical Director James Allison
Vehicle Technology Director Tad Czapski
Chief Designer Tim Densham
Operations Director John Mardle
Head of Aerodynamics Dirk De Beer
Sporting Manager Steve Nielsen
Chief Race Engineer Alan Permane
Chief Test Engineer Christian Silk
Technical Coordinator, Red Bull Racing Fabrice Lom
Race engineers, Car 7 Simon Rennie
David Greenwood
Race engineers, Car 8 Phil Charles
Ayao Komatsu
Хулкенберг изкара на пистата новия FW31
January 19, 2009
Еклестън: Отборите няма да получават повече пари
January 20, 2009
Comments
There are no comments yet. Be the first one to express yourself!
Articles 
Latest Videos 
Wallpapers and Pictures 
